Mdadm: Difference between revisions
Line 27: | Line 27: | ||
==Scrubs== | ==Scrubs== | ||
On Ubuntu, md will automatically scrub on the first Sunday of every month using a systemd timer. | {{main | Archwiki:RAID#RAID_Maintenance}} | ||
On Ubuntu, md will automatically scrub on the first Sunday of every month using a systemd timer.<br> | |||
During a scrub, you can check the status with | |||
<pre> | |||
cat /proc/mdstat | |||
</pre> | |||
You can check for bad blocks using | |||
<pre> | |||
cat /sys/block/md0/md/mismatch_cnt | |||
</pre> |
Latest revision as of 02:51, 28 June 2023
Mdadm is used to create linux MD raids.
Usage
# Check the status of /dev/md0
mdadm -D /dev/md0
Create a raid array
See https://www.tecmint.com/create-raid-6-in-linux/
First use gdisk to create a linux raid partition (FD00) on all your disks. Note that is purely convention and is optional.
Then run the following to create /dev/md0.
mdadm --create /dev/md0 --level=6 --raid-devices=4 /dev/sda1 /dev/sdb1 /dev/sdc1 /dev/sdd1
# Now you have a block device /dev/md0 on which you can add LUKS, LVM, or a filesystem.
Add hot spare
See https://tuxfixer.com/how-to-add-hot-spare-volume-to-the-existing-mdadm-software-raid-array/
mdadm --add /dev/md0 $DEVICE
Scrubs
On Ubuntu, md will automatically scrub on the first Sunday of every month using a systemd timer.
During a scrub, you can check the status with
cat /proc/mdstat
You can check for bad blocks using
cat /sys/block/md0/md/mismatch_cnt