Mdadm: Difference between revisions
| Line 40: | Line 40: | ||
==Changing Raid Levels== | ==Changing Raid Levels== | ||
Note: I haven't tested this. | Note: I haven't tested this.<br/> | ||
This procedure is primarilly for expanding when you get a new disk. | This procedure is primarilly for expanding when you get a new disk. | ||
Revision as of 22:33, 30 November 2024
Mdadm is used to create linux MD raids.
Usage
# Check the status of /dev/md0
mdadm -D /dev/md0
Create a raid array
See https://www.tecmint.com/create-raid-6-in-linux/
First use gdisk to create a linux raid partition (FD00) on all your disks. Note that is purely convention and is optional.
Then run the following to create /dev/md0.
mdadm --create /dev/md0 --level=6 --raid-devices=4 /dev/sda1 /dev/sdb1 /dev/sdc1 /dev/sdd1
# Now you have a block device /dev/md0 on which you can add LUKS, LVM, or a filesystem.
Add hot spare
See https://tuxfixer.com/how-to-add-hot-spare-volume-to-the-existing-mdadm-software-raid-array/
mdadm --add /dev/md0 $DEVICE
Scrubs
On Ubuntu, md will automatically scrub on the first Sunday of every month using a systemd timer.
During a scrub, you can check the status with
cat /proc/mdstat
You can check for bad blocks using
cat /sys/block/md0/md/mismatch_cnt
Changing Raid Levels
Note: I haven't tested this.
This procedure is primarilly for expanding when you get a new disk.